• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

1+1=245

^ thank you

got myself some WADE light covers for the ultimate aero!


IMG_20160217_152724007_HDR_zps6i0nwkes.jpg


IMG_20160217_152730304_zpsraw9twt5.jpg



and to keep them leafs out and kill the aero, I got a snow scoop too... attached via zipties
IMG_20160217_154821494_zpsyjxjc8al.jpg


100amp denso (belts are shorter and I only had one)
IMG_20160217_154837637_zpsv8whxj6y.jpg


I finally got around to installing the extra door seals. It really cuts down on wind noise.
IMG_20160217_154814418_HDR_zpsqbtukhwn.jpg


fix one thing another fails...
one of my ac accessory bolts was missing so the ac compressor was crooked ... it took out the bearing which then took out the magent.... well I replaced the magnet but now the compressor is super hot when it turns on, and makes a bad noise. I need to take it to a shop to have another one put on.
While I was in there I swapped to YoshiFabs aluminum bushings
IMG_20160209_131712457_zpsalp2oksl.jpg
 
Last edited:
Great colour. I have just bought a '93 240SE here in the UK in 415 Fjord Blue. Looking good!

thank you. Soon I'll be painting the hood to match the rest of the car

Today I finally got around to replacing a windshield. Late model flush seal FTW
Also fixed page two of this thread

started to work on the fist post listing everything that's been modified on this car

IMG_20160503_143833283_HDR_zpsjdcjl7vx.jpg
 
yesterday I got around to installing Yoshifab torque rods.
IMG_23321_3_zpstp68qgdo.jpg


today I had enough time to Dynamat EXTREMEEEE!!!!!!!!!! only on the driver front door... hopefully tomorrow I'll get around to the roof and other doors (translation - 3 months from now)
whole outer panel got covered with few patches on the inner frame
IMG_38871_zpsroqq6j2e.jpg
 
I got around to doing the roof this morning. Stopped at the cargo area. I also left some off around the roofrack holes for when I get around to welding them...

morning sun helped a lot to get the factory stuff off
IMG_8620_zpsk3gsjmz3.jpg


IMG_8621_zpsteqgoirl.jpg


IMG_8623_zpsn3tgolex.jpg
 
Huge sound reduction on highway just from the 2/3rd roof and one door done. The other side effect was the cabin HUGE heat reduction, it was mid 90s today. On the highway I rolled my windows up and only had the front kickpanels open, normally the heat would be unbearable but now it was surprisingly quite comfortable.

I'm so impressed that I ordered more dynamat and dynapad (used to block heat) both of which I will add to this car and my wife's black 850. I wont tell her that Im installing anything and wait for results.

obligatory #fakeSTANCE photo from today
IMG_20160511_160444911_HDR_zpse62dmmxz.jpg
 
Last edited:
Back
Top