Shinchan
Member
- Joined
- Jun 28, 2018
- Location
- Lafayette, CO
Trying to wrap up a microsquirt/b20 project. I'm using a missing-tooth wheel bolted to the crank pulley. I originally had my crank sensor mounted 240 degrees from TDC, turns out that that's not a good spot/too far off of TDC.
Looking for ideas on mounts and mount points to get the sensor mounted in the correct range. Unfortunately the ideal spot is right in the center of the fan belt and there just don't seem to be any decent spots that I see to mount a bracket that won't get in the way of the belt or be too close to the pulleys or put the sensor too close to the alternator.
Would love to see how folks have their sensors mounted and if you used a vendor-supplied mount, where did you get it? My fabbing skills are not the best.
Looking for ideas on mounts and mount points to get the sensor mounted in the correct range. Unfortunately the ideal spot is right in the center of the fan belt and there just don't seem to be any decent spots that I see to mount a bracket that won't get in the way of the belt or be too close to the pulleys or put the sensor too close to the alternator.
Would love to see how folks have their sensors mounted and if you used a vendor-supplied mount, where did you get it? My fabbing skills are not the best.