Search results

Thank you, already found 24mm spacers, but price here... 150€ for one axle. 🙄 I found a 2-pin connector on the right front fender, next to the coolant expansion tank, don't know for what it is? Do someone know for what are these two connectors from photos? First one under intake manifold...

P80 (S70, 850, V70 I, C70 I) has 65.1mm center hub bore, bolt circle 5x108 like 940. Will have 7.5'x18' Triton from C70 I T5 in the near future and try to mount them, they have offset 43mm. V2A screws are here 😍

Nice project! 👍🏻

Today my mother's manual 02' C70 2.0T (I know, whiteblock 🙄) with BSR 226hp tune (birthday present from son 😎) and turbocharger from B5244T7 2.4T - because exhaust side is bigger - less backpressure lowers the cylinder head temperature - (TD04HL-13T vs original TD04L-12T) is becoming new...

Headlamp brackets are bit rusty, screws too. So bought 150 new stainless steel screws with flange heads in different sizes. I will sandblast these brackets and paint them. Next episode is to collect more $ to buy new clutch (thrust bearing make noises) and slave cylinder, alternator (make them...

Of course, there will be no overpressure, but the turbocharger, thanks to this valve, does not pump air over and over again. It doesn't make sense what they did there. The engineers had to really try to squeeze so little power out of such an engine. 😂 Where is your fuel pressure regulator...

Today some small parts arrived, so in the afternoon.. I am going to change most rusty screws and nuts with exactly the same stainless steel ones or original Volvo (BUFO).

New gearbox mount, maybe not full restoration but enough for the next 5 years, two layers of Brunox Epoxy, one layer of lacquer, when on the car one layer wax tomorrow. :-) I found, that on my B230FT4 is a 4mm hose between inlet manifold and Y-pipe from crankcase ventilation, there...

I ordered already new cooler brackets and want to buy new top cover, because on the right side it is impossible to screw out the screw which holds the bracket. On the other side as you see, someone has already drill another holes, because original screw is broken. Air box lashes repaired...

Thank you, it's a long way to make it perfect. Every, even smallest part is on the way, every cap etc which was missing, already on the way to me. Several screws that were rusty are out. 😊 Under the hood for now it looks a bit better, several cables attached, new Samco silicon underpressure...

Ferrita Exhaust already sit, it was a pleasure to mount it, everything suits exactly like original. On the C70 have Simon's stainless steel exhaust with one muffler and it wasn't P&P... Not too sporty? On the way is EZK chip with goldbox from jpstyling.com Now thinking about chip for LH2.4...

Hope Ferrita will be not too loud. The second owner had it for last 18 years and took great care of it.

That's nice to be here and have my first turbobrick. My name is Arek from Poland. I have already C70 I Convertible 4T5 swapped with 400hp and M56 gearbox with quaife torsen diff. C70 is ready so there is need for a new project. :) The car has central locking, OBD port, ECC, cruise control...