Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
Hello Guest, welcome to the initial stages of our new platform! You can find some additional information about where we are in the process of migrating the board and setting up our new software here
I want to replace the tranny filter, do I need to detach the dipstick tube before dropping the pan? there's 2 nut, one closer to the pan and bigger, one smaller (about 1in) immediately after it, which one do I turn? they are super tight, so I don't want to turn the wrong one,
or should I detach...
how much % can brand new catalytic converter reduce the Nox output?
is it enough to lower to the passing limit?
this is the result of the old CAT (the honeycomb is intact, but looks black)
what else I can do to reduce Nox?
as you can see in the picture, I need to fit this new catalytic converter, it was almost going to fit in at first, so I expanded it, but the expander cannot go further into the narrower section, and this is as far as I can go;
is there some kind of "quick and dirty" way to seal this up (with no...
the bushings seems superhard, will not give at all or flex(especially (1))
should I heat it up to make it soft??
any tool to push it in?
makes me want to cut/grind down (1), I think it will stay with or without it.
what tool should I use to remove the C clip? and tips?
1994 960 140K miles
good:
I always see it in the neighborhood
that pearl white is awesome,
is this such rare color to worth getting?
(gives me an impression it is a minter)
(it always sits on the drive way)
he said it's got new radiator
I do see from the reservoir (the container is so...
what is the official name for this color?
how rare is it?
you guys like it?
questions
http://forums.turbobricks.com/showthread.php?t=251193
http://victoria.kijiji.ca/c-cars-vehicles-cars-trucks-1994-Volvo-960-Sedan-W0QQAdIdZ328890388
http://claspics.com/466/542759/
and rear on the ground.
I insist from the rear and put front on dolley
he said no matter for manual car, just put in neutral,
it sort of make sense in a way
but I recall some where it's not good, what part of the car suffer?
http://www.youtube.com/watch?v=14eRGYlJ-hQ
1980 volvo 242 DL
it has manual 4 speed, and start to produce that sound at 60mph
and louder if I momentarily lift off the gas.
how do you describe this noise?
you may have to turn up the volume
where does it come from?
my car is the one that has no tach
i saw in the yard today a 1979 244 GLE(?) with tach and v6 engine
do I only need the instrument cluster?
or do i need any sensor from the v6 engine for the tach to work? where is it located on the v6 engine?
i saw a "mechanic's special" deal, he said the car needs timing belt, it slips off one time
and he try to put it back on, and engine starts to jump and then die off, and the belt slips off again
does wrong ignition timing makes engine jump like that?
i am wondering if he didn't do it right, or...
http://www.youtube.com/watch?v=bIdtkrbWFAQ
what's that noise that goes on and off
it doesn't have that sound initially start up
and the sound doesn't seems to relate to engine rpm, or if i press the clutch or not
is it fuel pump? which one?
how do i open the hood without the cable??
i was doing some major front end repair, so i took a lot of the stuff out (including the hood cable) then i accidentally slam it close!
but good thing is i have the grill area open
so i am having no start issue, 91 740 turbo
both in tank and main fuel pump make buzzing noise, so maybe it's not that
and FPR have no fuel dripping out
i replaced spark plug and dizzy cap and rotor sometime ago, i think they are fine, but i haven't test by sparking against the chassis( it's...
i have a 94 940 NA that i took the e fan off for repair,
want to make sure something when i install
the connector goes to the socket near the battery right? and is the socket that is the closest to the driver?
another single wire is ground? where does it go usually? (i can't find the place to...
I was at the junkyard, and saw a 5 spoke AT Italia rim on a 960, smooth round spoke,I will post pic later
1.should I get it? how much do they worth? (if JY charge more than that, then i shouldn't get it)
2. will 960 wheel fit on 740?
anyone tried painting bumper? can you describe the process and pictures?
how about the "forever black" on ipd catalog? ($14.50)
i was tempted to just try regular paint,
should i go with gloss or flat?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.