940 T splash shield under radiator/intercooler

[nedc]

I've had no luck googling this- does anyone have a pic or source for the splash shield thing that goes from the engine belly pan to under the radiator/intercooler and connects to the tabs on the front bumper cover? I have the belly pan that goes under the engine, but my 94 940t hasn't had this other one since I got it and I would like to get or fab one...if I knew what it was supposed to look like. 940 people hollar if you can help!

 

[PCH]

Volvo Part #: 1358535​

940 - Radiator Gravel Shield (Air Guide) Question (Volvo Part #: 1358535)

Good evening everyone, I searched junk yards for 3 years for an unbroken radiator gravel shield/air guide (Volvo Part #: 1358535) and finally found one. I went to install it yesterday on my 1992 940 Turbo only to very sadly realize that my radiator lacks the 3 necessary holes for mounting the...

www.turbobricks.com

 

[nedc]

That's it! Thanks for the link.

 

[conehead]

I'm also in the process of trying to fab one. I'm making an aluminum belly pan and likely one of these as well, post what you end up using, I'm curious

 

[2manyturbos]

I've had no luck googling this- does anyone have a pic or source for the splash shield thing that goes from the engine belly pan to under the radiator/intercooler and connects to the tabs on the front bumper cover? I have the belly pan that goes under the engine, but my 94 940t hasn't had this other one since I got it and I would like to get or fab one...if I knew what it was supposed to look like. 940 people hollar if you can help!

I think I have 3 of those in good used condition. PM me if you would like to buy one.

 

[nedc]

I'm also in the process of trying to fab one. I'm making an aluminum belly pan and likely one of these as well, post what you end up using, I'm curious

Well right now I'm using a piece of 1/4" plywood I had lying around, so don't follow my example! Roy, I may PM you about one of yours. Just not sure they make enough of a difference to mess with...

 

[PCH]

Just not sure they make enough of a difference to mess with...

I put about 150K Miles on my 945T without having one.

 

[conehead]

Well right now I'm using a piece of 1/4" plywood I had lying around, so don't follow my example! Roy, I may PM you about one of yours. Just not sure they make enough of a difference to mess with...

Well if you want a super slick aluminum setup, let me know. Planning on making a couple extras in case someone wants them