• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

torque plate for redblock around Houston

jjona5

Member
Joined
Nov 15, 2017
Location
Houston
Anyone have a torque plate I could rent? I really dont want to buy one for one build. I have read people use the ford version of the 2.3l but I'd rather use the correct torque plate. I picked up yoshi rods and pistons I want to put in after I get my 6 speed swap buttoned up.

Also before I get scolded for not searching I did. I also asked deeworks about it and they don't rent I'd have to buy.

http://www.turbobricks.org/forums/showthread.php?t=282535
 
Last edited:
Yes John, it will.

Not sure why the concern over using the Ford plate vs. a 'correct' Volvo plate. The bore spacing, bore diameter, and bolt spacing is the same between the two. I laid a head gasket over the Ford one and it was spot on, even per my machinist's knowing eyes.
 
Back
Top