Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
Hello Guest, welcome to the initial stages of our new platform! You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Looking for a part number for the small o-ring that goes around the banjo bolt to secure the oil cooler elbow to the block?
In the middle of resealing the oil cooler, and there is no o-ring to even reuse?
This is on a 93 945ti.
Thanks again,
Bret.
Hello all,
I got a 75 242. The question is which kickdown cable should I use to put an AW71 in my 75?
I seem to find nice GEMO brand ones for the turbo cars. Are these sufficient to work in my 75? Thanks in advance.
P.S. I could not afford a T5 swap so thats why AW71. Just about done...
Hey TB peepz,
Been awhile since I have thrown a shindig so here goes. The plan is to meet and greet at my place.
859 Byron Dr. South San Francisco
Plan a nice drive down the coast a way. Then wrenchin beers, fat BBq and evening bonfire. Who is down? I have plenty of space for people to...
From experience who has run the D cam, in a NA? With adjustable cam gear? Advanced, retarded? I am planning on putting one in my brick. It is an auto to boot..:oops:
Got a 96 850 na here at the shop. I am in the process of replacing all of the cooling system hoses and such. I removed the plastic firewall passthrough for the heater hoses. Unfortunately i dont seem to have the proper arrangement of o rings and spacers on the engine bay side of the plastic...
Soo me and the lady picked up 122powers 242. The car is slowly getting a stage 0. Replaced cap n rotor plugs did a LOF. Also changed the fuel filter. Up untill the filter change the car was running pretty good. Now it stumbles at higher rpm and feels gutless in general. I know i need a...
Hello all you brickers. I have a bit of a problem with my 91 NA 245. I am in the midddle of rebuilding a B230ft and I had a set of injectors out of a lpt 850. I grabbed them at pic n pull and wanted to make sure they worked ok. I knew the car would bog down at idle, decel or anytime I wasn't...
Looking on FCP's website they stock a meyle front strut mount for the 240. Is it any good or should I pony up and go to the stealership? I know Uro and scamteck are junk but what about Meyle?
Bret
How to make them work together? (91 245) I know earlier housings will work but I want to make my housings work with the Decarbon's. The current strut housings do not allow the gland nut to engage threads on the housing. I may grind off some metal on the bottom of the insert?
Thoughts?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.